how to thread a ratchet strap

how to thread a ratchet strap

5 hours ago 3
Nature

To thread a ratchet strap, follow these steps:

  1. Open the ratchet fully and position it so the slot (mandrel) is horizontal.
  2. Take the open end of the strap (the loose webbing) and feed it through the slot in the center rotating spool (mandrel) from the back to the front.
  3. Pull a good length of the strap through, leaving some slack.
  4. Flatten the strap so it is not twisted.
  5. Start ratcheting the handle up and down to wind the strap around the spool, tightening it.
  6. Continue ratcheting until the strap is tight enough for your load.
  7. To release, pull the release lever, open the ratchet fully, and pull the strap out.

Key tips:

  • Make sure the strap is fed through the mandrel correctly and not twisted.
  • Pull enough strap through before ratcheting; not too little.
  • Ratchet in a smooth pumping motion until tight.
  • Avoid overtightening to protect the strap and cargo.

This method secures cargo effectively using the mechanical advantage of the ratchet to tighten the strap.

Read Entire Article