You should cut LED strip lights only at the designated cut points marked on the strip. These cut points are usually indicated by a small line, a scissors icon, or located between copper pads or copper dots on the strip. Cutting at these points ensures that you do not damage the circuitry and that the strip will continue to work properly after being cut

. Key details about cutting LED strips:

• The cut lines are typically between copper connectors or pads.
• Look for a scissors logo or a dashed line on the strip as a guide.
• Do not cut on silver lines or areas without the cut mark, as it may ruin the strip.
• Use sharp scissors to make a clean, straight cut.
• Always disconnect the power supply before cutting to avoid electrical hazards.
• After cutting, you can reconnect strips using soldering or connector clips if needed.

Following these guidelines will allow you to safely customize the length of your LED strip lights without damaging them